User Parameters - Okuma OSP-U100M Operation Manual

4203-E P-368
SECTION
3
DESCRIPTION OF PARAMETER
AND SETTING PROCEDURE
3.
User Parameters
The following user
parameters are available.
Initial Setting
Value
No. Display Screen Contents
Setting Range Setting Unit
P PROG LIMIT
WRK
1 Software-based
P-directional and
N-directional
travel end
limits disclosed to users.
Displayed
in the work
coordinate system.
Depends on
machine
specification
Selected
unit
system
-99999999 to
+99999999
N PROG LIMIT
WRK
2
Same as above -99999999 to
+99999999
Selected
unit
system
P PROG LIMIT
3 Software-based
P-directional and
N-directional travel
end
limits disclosed
to
users.
Displayed in the machine
coordinate system.
Same as above -99999999 to
+99999999
Selected
unit system
MC
N PROG LIMIT Same as above
4 -99999999 to
+99999999
Selected
unit system
MC
G60 OVERRUN Amount of a jump in
uni-directional positioning.
The direction in which
positioning is made is set
by the NC optional
parameter (bit), No. 19.
5 1000 0 to 30000 Selected
unit system
AMT
BACKLASH 6 Backlash
compensation
amounts for individual
axes are
set.
0 -1000
to
1000 Selected
unit system
CLAMP IN-P Clamp in-position width
for each axis.
(If
the setting is "0", clamp
in-position check
is not
carried out.)
Selected
unit system
7
0
Oto 1000
The P PROG LIMIT WRK and P PROG LIMIT MC display
the
same data in the coordinate values
in the
work
and machine
coordinate
systems.
If either of the data
is changed, the data of the other
parameter is
changed accordingly. Similarly, if either of the data is set in the program using G22, both of the parameter
data are changed.
This is also true for N PROG LIMIT
WRK and N PROG LIMIT MC.