Other Commands; Back Up Command - Okuma OSP-U100M Operation Manual

4203-E P-172
SECTION
1
DATA SETTING
-
If the device name is not specified at the PUNCH operation, the setting will be determined by optional
parameter
word No. 103 (initial value: 0, setting range: 0-11). The devices which correspond to the
setting values are shown below.
(This parameter setting becomes valid when power
is
switched
ON.)
Setting Value 0
2 1 3 5 6 7 8 9 10
4 11
Device
Name CNO CN1 CN2
CN3 CN4 PP MDO FDO MD1
FD1
FD2 FD3
The "CNO" device name shown above represents the same device as the "TT" (teletyper) name.
- If the file name is not specified, a default file name will be designated
according to operation function and
device in question.
The default file name is "A.TOP". This function features
separate
default values for the file and extend
names. If only the extension name is omitted, it will be designated as ".TOP".
3-4. Other Commands
The NC has other commands as explained below:
3-4-1 .
Back Up Command
: Data such as tool length
offset, cutter radius compensation, origin of work
coordinate
systems and parameter except system parameter
is backed up to the memory in a
preset
interval. Therefore, turning off the power to the control right after renewing the data will
cause the data to stay as it was without being updated.
The execution of the back up command will update the data even when the
power is turned off.
Operating procedure is shown below:
(1)
Press the PARAMETER,
ZERO SET or TOOL DATA key.
(2)
Press function key [F8] (EXTEND).
The commands will be changed as indicated right.
=BA
[EXTEND]ÿ/
READ
PUNCH
VERYFY BACKUP
CED © GD © © © GZ
F8
"=BA" is displayed.
After the completion of
backup, "=* is displayed.
Press [F8]
([EXTEND]).
Press [F7] (BACKUP).
(3) Press function key [F7] (BACKUP).
"= BA" appears on the console line and back up is continuously executed.
After back up completion, "=" will appear on the screen.
Now, all the data has been backed up and the power
to the control may be turned off
at
any time.