Nc Optional Parameter (Word) - Okuma OSP-U100M Operation Manual

4203-E P-378
SECTION
3
DESCRIPTION OF PARAMETER AND SETTING PROCEDURE
6.
NC Optional Parameter (Word)
The following optional parameter (words) are available.
For NC optional
parameter (word), those listed below are available. The
parameter numbers given in the
following table are keyed to the numbers displayed on the
NC OPTIONAL PARAMETER (WORD) screen.
Parameter
Initial Setting
Value
Setting
Range
Contents Item
No.
Tape feed holes
in punching
For a punchout in the PIP (transfer) mode,
there
is a tape
feed before the program is
punched out, which is followed by
tape
feed. The number of feed holes is set by
this parameter.
1
600
1
to 10000
(holes)
Defaults of
tape
lengths in
divided punching
A file of part programs
which is too long to
be stored in a roll of paper tape is divided
into smaller files
to
be punched
out.
The
lengths of the divisions are closed at the
breaks of each block, so that the setting is
slightly different from the
actual tape length.
A divided punchout gives the beginning of
each
tape part a file
name. Note that
the
setting does
not
include the lengths
corresponding to the
file name and feed
holes.
2 180 1 to 300
(m)
Decelerating
ratio of cutter
radius
compensation
corner override
3
100 1 to 100
I
l (%)
/
8
i
L
1
1
B
C
!e
(s
N1 X_Y_ FI
N2 X_Y_
F2
A : Override ON point
B : N1
positioning
C : Override OFF
point
r : Decelerating ratio
6 :
Corner's
internal identification angle
Internal
identification
angle of
cutter
radius
compensation
corner override
4 1 to 179
(deg)
90
1
I
FI
I s.
j-*-
{
e
»
p
2
Distance