Parameter Setting - Okuma OSP-U100M Operation Manual

4203-E P-181
SECTION
1
DATA SETTING
6.
Parameter Setting
To perform NC operations, for example positioning, program editing, and so forth, data such as axis travel
ranges,
tape output code, and others, are predetermined for each individual function. However, there are
cases in which these
data needs to be changed in accordance with the change in operation conditions.
The data elements used to control NC functions are called parameters.
The parameters can be classified into 18
types
as indicated below.
(1) Display selection (selection for display/not-display of
parameter
setting
screens)
(2) Common variable
(3) User parameter
(4) G/M code macro
(5) NC optional parameter (long word)
(6)
NC optional parameter (word)
(7) NC optional parameter (bit)
(8) Input unit system
(9) NC optional parameter - RS232C (CNO:)
(1 0) NC optional parameter
-
Spindle (OKUMA VAC)
(11) Machine axis parameter
(12) System
parameter
(13) Pitch
error
compensation data
(14) NC run timer
(15) Spindle load monitor
(1 6) Tapping torque monitor
(17)
Machine user
parameter
(18)
Machine
system parameter
Contents and setting procedures of parameters are detailed
in
IV "PARAMETER".