Other Functions - Okuma OSP-U100M Operation Manual

4203-E P-71
SECTION 3 MANUAL OPERATION FUNCTIONS
6.
Other Functions
These include the COOLANT, OIL MIST, AIR BLOW, OIL HOLE, CHIP CONVEYOR and DISPLAY
SCREEN.
(1) Operation keys
DESKS
These keys are flat keys. When a key
is
pressed, the LED at the upper left corner
turns on and the
corresponding function is turned on. When
it is
pressed again, the function is turned off
and the lamp
goes off simultaneously.
(2) Keys
(a) COOLANT, OIL MIST, AIR BLOW, OIL HOLE
Setting of these keys is effective independent of the operation mode, whether MANUAL, MDI or
AUTO.
For
both
M08 and M09,
the M
code entered last becomes effective in
the
same way as the coolant
switches.
(b)
LUB.
When the key is pressed, axis slideway is lubricated.
(c) DISPLAY ON/OFF
Display is disabled.
Display is enabled.
Turning this key off when display screen
is not
required can elongate service life of
display screen.
ON
OFF
NOTICE : Y/Z AXIS CROSS RAIL (W) CLAMP
When
these
axis clamp switches set
at
the upper
position, the corresponding axis (Y for
spindlehead, Z for ram and W for crossrail) is clamped with the indicating lamp lighted up.
Turning the switches
to the lower position unclamp the axis and the indicating lamp goes off.
If the axes
are
clamped during axis feed, the axis movement is brought to a stop and clamped.
However, this operation will cause the guideways
to
be worn rapidly and therefore
clamp/unclamp operation should no be carried
out
while the axes are being fed.
When power is turned on to the machine, X-, Y-axis and crossrail (W-axis) are in the unclamp
state.