Machine Axis Parameter - Okuma OSP-U100M Operation Manual

4203-E P-428
SECTION 3 DESCRIPTION OF PARAMETER AND SETTING PROCEDURE
13. Machine Axis Parameter
The machine axis parameters designate the settings for data related to the machine axis. All the
machine axis are listed below, though some may
not
be present at certain machine models.
MA axis: ATC Magazine axis 1
MB axis: ATC Magazine axis 2 (Multiple magazines)
MC axis:
ATC Magazine axis 3 (Multiple magazines)
TS axis: ATC change arm rotation axis
Tl axis: ATC change arm IN/OUT axis
PA axis: APC axis
1
PB axis: APC
axis 2
PL axis: Multi-pallet magazine axis
AT axis: Attachment axis
AA axis: Attachment magazine axis 1
AB axis: Attachment magazine axis
2
CA axis: ATC carrier axis
CB axis: AAC (AT) carrier axis
WA axis:
Crossrail (EC-W) axis
The machine axis parameters are listed below.
<Screen 1>
Factory Set
Initial Value
mm (in.)
Display Screen
Name
Setting
Range
Contents Setting Unit
P TRAVEL
LIMIT
P-directional travel end limit in
the machine coordinate
system
Depends
on
machine
specification
Selected
unit system
-99999999 to
+99999999
N TRAVEL
LIMIT
N-directional travel end limit in
the machine coordinate
system
Same as
above
Same as
above
Same as
above
IN POSITION "In-position confirmation zone"
at
positioning
Same as
above
0.000
to
10.000
Same as
above
CLAMP
"Positioning clamp confirmation
zone"
at
positioning
Same
as
above
Same as
above
Same as
above
ZERO-POINT Distance from encoder zero-
point to
control zero-point
Same as
above
Same as
above
0.000 to
99999.999
ENCODER
OFFSET
Encoder's zero cross shift
amount
Same
as
above
Same as
above
-99999.999 to
99999.999
BACKLASH Back lash compensation
amount
Same as
above
Same as
above
Same as
above
OVERRUN Overrun amount at single-direc¬
tion positioning
Same
as
above
Same as
above
0.000 to
99999.999
AMT