Search Command - Okuma OSP-U100M Operation Manual

4203-E P-163
SECTION
1
DATA SETTING
3-2-2.
SEARCH Command
=F
[EXTEND] |
J
ADD CAL
SEARCH
ITEM
t
ITEM
I
SET
T is display.
\p,as,F4)
(SEARCH).
In the subcategory group, which involves several data elements, the screen display is, sometimes,
greater
than one page. This SEARCH command, engaged by function key [F4], may be conveniently used
to set
the
cursor
with ease, although it is possible to place the cursor
at the desired data using the page key and
the cursor key.
Operating procedure is given below:
(1)
Press function key [F4].
This produces display of "F' on the
21st
line
on
the display screen.
(2)
Key in a data
number on the keyboard.
Display of "F" is followed by this particular data.
(3) Press the WRITE key.
This allows the cursor to be positioned at the data number specified. If the current screen does not
include the data number, then the screen is switched over until that data number appears and the
cursor is positioned there.
If there
is nothing
corresponding
to
the data number entered, the cursor is then positioned as follows:
(1) When smaller
The cursor is positioned
at the first data.
(2) When greater
The cursor is positioned at the last data.
The screen for setting bit type data, NC optional
parameter (bit))
allows the simultaneous setting of both
parameter
number searching and
parameter number setting.
(1) Press function key [F4].
(2) Key in the parameter number.
(3)
Key in a comma {,).
(4) Key in a bit number.
(5) Press
the
WRITE key.