Clearing/Setting Tool Numbers - Okuma OSP-U100M Operation Manual

4203-E P-180
SECTION
1
DATA SETTING
(6) Press the WRITE key.
This sets the correspondence between the tool number and the
tool pot number.
[Supplement]
1
.
If the tool number already used is again entered for a new toolpot, an alarm occurs.
2. An attempt to set a tool number for atoolpot which has a
dummy tool in it causes an
error. In this case, cancel the dummy tool code by entering "*"
and set
5-2-3.
Clearing/Setting Tool Numbers
it is possible
to clear
tool numbers set on the
"*POT NO./TOOL NO. TABLE*" screen at one time,
or
to
set
tool numbers which correspond to toolpot numbers (having same numbers) on the "ATC POT
NO./TOOL
NO. TABLE"
at
one time.
Note tool numbers can not ben set at one time unless the correspondence between toolpot numbers and
tool numbers are
all
cleared.
Operating Procedure
(1)
Clearing tool numbers
(a) Press the TOOL DATA key.
(b) Press function key [F7] (ITEM J).
The CRT will display the page of "*POT NO./TOOL
NO.
TABLE*".
(c) Key in "ATC" through the keyboard and press the WRITE key.
The following message will be displayed on the screen.
Tool table initialize OK? (Y/N)
(d) Key in "Y" and press the WRITE key to clear tool numbers.
Key in "N" and press the write key to cancel clearing tool numbers.
(2)
Setting tool numbers
(a) Press the TOOL DATA key.
(b) Press function key [F7] (ITEM |).
The CRT will display the page of "ATC POT NO. /TOOL NO. TABLE".
(c) Key in "TSET" and press the WRITE key.
[Supplement]
When an attempt is made to
set tool numbers without clearing the correspondence
between toolpot numbers and
tool numbers,
no data will
be set.