Power On/Off Operation; Turning On The Power - Okuma OSP-U100M Operation Manual

4203- E P-49
SECTION 2 POWER ON/OFF OPERATION
SECTION
2 POWER ON/OFF OPERATION
This section describes the basic power ON/OFF operation procedures.
1.
Turning on the Power
Procedure:
(1) Press the CONTROL ON switch
to turn it ON.
Power is turned
on to the NC and the system software, resident in the
memory is loaded
to the RAM area. While the software is being loaded,
the file names are displayed on the screen. After the completion of
loading of the system software, initial setting is made for the peripherals.
Upon completion of initial setting of the peripherals, the screen as
indicated below is displayed. The NC can now operate correctly.
I CONTROL ON
AUTO OPERATION N
197/07/15
14:10:00
X
2299. 582
0
Y
3385.812
N CO 3
Z
-1883.255
F 0.0 H 0
S 0
D
0
PROGRAM ACTUAL PART
BLOCK
SELECT
|
POSIT. PROGRAM
|
DATA SEARCH
CHECK
[EXTENDly
DATA
[Supplement]
If
an alarm or error occurs instead of the display of the
screen
as indicated to the right,
take proper corrective measures by referring
to
the separately prepared manual,
"ALARM & ERROR LIST".