Mirror Image In The Work Coordinate System - Okuma OSP-U100M Operation Manual

4203-E P-101
SECTION 5 AUTOMATIC MODE OPERATION
[Supplement] 6. While the mirror image function is active, G codes which indicate the direction of
axis
movement and
I, J, and K commands are changed
as needed.
Circular interpolation (G02.G03)
Cutter radius
compensation (G41.G42), etc.
7.
The positioning direction for 660 one-direction positioning is not changed even in a
mirror image ON state.
Example:
Y
Mirror image ON
Mirror image OFF
X
8.
On the display screen, the mirror image ON axes are
identified by the
before the axis address of X, Y, Z,
etc.
sign
12-1
.
Mirror Image in the Work Coordinate System
Normally, when programming is executed in
the local
coordinate
system, the mirror image
function is
effective in the local coordinate system. However, it is also possible
to activate the mirror image function in
the work coordinate system currently selected by changing parameter data.
(1)
Parameter Setting
Whether the mirror image function is activated in the local coordinate
system or in the work
coordinate system
can
be set at
the following parameter:
NC Optional Parameter (bit) No.
34, bit 2
The mirror image function
is
activated in the local coordinate
system. 0
The mirror image function is activated in the work coordinate system.
1
: (1) The initia| setting is
(2) When the setting has been changed, press function key [F7] (BACKUP). After the
completion of backup operation,
turn
off the power
to
the NC and turn it back on again.
The new setting does
not
become effective only by changing the setting.