Sequence Stop (Option) - Okuma OSP-U100M Operation Manual

4203-E P-96
SECTION
5 AUTOMATIC MODE OPERATION
7.
Sequence Stop (Option)
This is the function to
stop the program execution at a desired sequence while
the automatic operation is
carried
out.
Note that the sequence
to
be set
must
be the one already executed. The operation stops in the
same manner as a single block
stop.
The operation can be resumed by simply pressing the CYCLE
START switch.
The operation procedure is described below:
(1)
Press AUTO.
0
Ml
E
nnn
|
V
II
W X
®©®0 (*
(7)®j®(*) (c**
5© [e>
i
OK/. X=
fÿ1l~Fi~|
|~Fn
l~F3l
f~F4~l [~ral rreH~F7~j fFSl PST|
/ /
7 7
7 7
7
/
15) Press WRITE.
(4) Key in the sequence
name.
(2) Press function key [F8] (EXTEND) twice.
(3) Press function key [F3]
(NUMBER STOP).
Fig. 5-5 Sequence Stop Operation
(1) Press the AUTO key.
(2) Press function key [F8] (EXTEND) twice.
Function name "NUMBER STOP" is displayed for function key [F3].
(3) Press function key [F3] (NUMBER STOP).
"NST" is displayed on the 21st line on the display screen.
(4) Key in the sequence name where the operation is to be halted on the keyboard.
(5) Press the WRITE key.
When
the
block of the specified sequence name is read during automatic operation, the blocks up
to
the sequence before the specified sequence are executed and the machine stops.