Time - Okuma OSP-U100M Operation Manual

4203-E P-267
SECTION
2 PROGRAM OPERATION
9.
Time
The NC's clock function contains counting time even when the power is turned off. Therefore, when the
power is turned on, the current time is displayed.
NOTICE : Since this time data is very important
for
the functions such
as
MacMan, alarm log, etc., do not
-
change it inadvertently.
The operating
procedure is
as indicated
below.
(1) Press function key [F1] (TIME).
The following
is displayed on the console line and the
system
becomes ready for the
input of time,
=T
1994.9.30
FRIDAY
15:13:52
enter time (H:M:S)I
=EX
=T
1994. 9.30 FRIDAY 15:13:52
enter
time
(H:M:S) ! _
BUNK
TIME
INIT DELETE RENAME DEFINE FREE
QJIDE
RUN
[EXTEND ]y
FI
] [
F2
1 (
F3
]
[
F4
[
F5
] (
F6
1 (
F7
]
[
F8
Press [F1] (TIME).
"=T
1994.9:30 FRIDAY1 5:1 3:52
enter
time (H:M:S)!" is displayed.
(2) Key in the present time through
the keyboard: hours, minute, and second, each delimited by
Example: 8:30:5
Press the WRITE key.
When time data has been entered correctly, the screen displays the set date, day of the week, and
time.
If
time data
has not ben entered correctly, the screen
displays "enter time (H:M:S)!" again,
requesting the operator to enter correct data.
(3)
[Supplement]
1
.
When time data only needs
to
be checked and does not need to be set, simply
press the WRITE key. The TIME command will terminate.
2.
The data setting range
is as
follows.
Hour
Minute
0 through
23
0 through 59
Second :
0 through 59
3.
After 23-hour 59-minute
59 second, the time changes to 0-hour 0-minute 0-second
and the date and the day of the week change.