Turning Off The Power; Emergency Stop - Okuma OSP-U100M Operation Manual

4203-E P-50
SECTION
2 POWER ON/OFF OPERATION
2.
Turning off the Power
Procedure:
(1) Make sure that all machine actuators have been stopped.
(2) Press the CONTROL OFF switch
to
turn it OFF.
If peripherals are connected
to
the NC, turn off power to these
peripherals.
QCOWTROL
OFF
: The NC backs up the data such as tool length offset data, cutter radius compensation
data, work coordinate
system
offset data, and
parameter data (excluding the
system
parameters)
in predetermined intervals. Therefore, if power is turned off
just
after
changing such data, the new data may not be backed up and the previous data might
remain unchanged.
In
such a case, execute the backup command before turning off the power
to ensure that the
data is changed without fail.
For backup operation, refer
to III. DATA OPERATION, Section
1,
3-4-1. "Back Up
Command".
3.
Emergency Stop
If
it becomes necessary
to stop the operation immediately, press the EMG.
STOP switch. The machine
stops
immediately when the EMG. STOP switch is
pressed.
The push-to-lock type switch is locked if the switch
is pressed; to unlock the
switch, turn it in the direction indicated by the arrow symbol. After unlocking the
emergency
stop switch, reset the NC and the NC is placed in the operation
ready state.
EMG. STOP
rm
s=
e-