Manual Operation Functions; Manual Axis Feed Functions; Manual Rapid Feed - Okuma OSP-U100M Operation Manual

4203-E P-51
SECTION 3 MANUAL OPERATION FUNCTIONS
SECTION 3 MANUAL OPERATION FUNCTIONS
The following manual operation is possible when the MANUAL
is
selected
in
the MODE selection keys on
the NC operation panel or when manual intervention mode is selected in the AUTO or MDI mode.
(1) Manual axis feed operation (rapid, jog, pulse handle)
(2)
Spindle
operation
(CW/CCW, stop, release orientation)
1. Manual Axis Feed Functions
1-1. Manual Rapid Feed
After selecting the axis
to
feed using the AXIS SELECT switches
on
the machine operation panel, press
the manual rapid feed switch corresponding to the direction in which the axis should move, and the
selected axis moves in the required direction at the predetermined rapid feedrate. The RAPID OVERRIDE
rotary
switch is used to adjust the rapid feedrate.
Operation procedure:
(1) Select the axis to feed by the AXIS SELECT switch.
-AXIS SELECT
x
Y
z
rrTr®
HANDLE
(2) Select the override rate by the RAPID OVERRIDE rotary switch.
This switch is operative while an axis is being fed.
OVERRIDE
IOJLSLTO
,80
5,
i
.90
O'
(3)
Press the manual rapid feed switch.
Press the RAPID/+ switch
to
feed the axis in the plus direction.
Press the RAPID/- switch
to feed the axis in
the minus direction.
The axis moves only as long as these switches are pressed
down.
When they are released, axis motion stops.
RAPID-
+