Display Select Screen - Okuma OSP-U100M Operation Manual

4203-E P-364
SECTION 3 DESCRIPTION OF PARAMETER AND SETTING PROCEDURE
1.
Display Select Screen (Selection for Display and Not-display of
Parameter Setting Screens)
(1) The display select
screen is
displayed only when "14 DISPLAY SELECTION" is selected
at the
DISPLAY INDEX screen. Note that it is not displayed by using function keys [F6] (ITEMf) and
[F7] (ITEMj).
To display the PARAMETER INDEX screen, press the WRITE key after pressing function key [F4]
(SEARCH). Note that it
is not
called out from the screen where machine
system parameters or
machine user parameters are displayed.
(2)
Move the cursor to the
parameter setting screen, for which the display or not-display status
should be changed
then press function key [F1] (SELECT/CANCEL). A red asterisk (*) is
displayed and cleared alternately each time function key [F1] (SELECT/CANCEL)
is pressed.
The
parameter setting
screens for which a red asterisk
(*) is displayed can be displayed.
(3)
To initialize the display/not-display setting for the
parameter
setting screens, press function key
[F3] (INIT).
In the initial state, the following
parameter
setting screens are displayed.
-
Common
variable
-
User
parameter
-
G code/M
code macro
-
NC optional parameter
- DNC-B
parameter (option)
-
NC run monitor (option)
-
Tolerance control
parameter (option)
-
DNC-C
parameter (option)
-
Rotary axis parameter (option)
-
Spindle overload monitor
parameter (option)
-
Tapping torque monitor parameter (option)
- Machine
parameter
- Thermal displacement compensation parameter (option)