Date - Okuma OSP-U100M Operation Manual

4203-E P-185
SECTION
2 PROGRAM OPERATION
2.
Date
The NC's clock function continues counting time even when the
power is
turned off. Therefore, when the
power is turned on, the current date is displayed.
NOTICE : Since this date data is very important for the functions such as MacMan, alarm log,
etc., do not
change it
inadvertently.
Date setting procedure is given below.
(1) Press function key [F1] (DATE).
The following is displayed on the console line and the
system becomes ready for the input of date.
=DA
1994. 9.30 FRIDAY 14:33:30
enter date (Y.M.D) !_
=EX
=DA
1994. 9.30 FRIDAY
enter
date(Y.M.D) !
14:33:30
MULTI
DIR
PIP EDIT
PIP LIST CONDENS
[EXTENDiy
DATE
\
Press [F1] (DATE)
=DA
1 994. 9.30 FRIDAY 1 4:33:30
enter date (Y.M.D) !_
_
This is only an example; current
date,
day of week, and time are
displayed.
(2)
Key in the year, month, and date with period put after each item following the prompt "!".
Example: 1994.9.30
(3) Press the WRITE key.
When the correct entry has been made, the display screen indicates date and a day of the week.
If the data entry is not
correct,
the display screen
requests data entry again.
[Supplement] 1
.
Entry
of only right two
digits is acceptable
for year entry.
2.
Pressing the
WRITE key without
entering the date ends the operation and nothing
occurs.