Sequence Number Search And Mid-Start - Okuma OSP-U100M Operation Manual

4203- E P-91
SECTION 5 AUTOMATIC MODE OPERATION
5.
Sequence number Search and Mid-Start
Sequence
search is
used
to start the operation from a required sequence of a main program. The
specified sequence is searched by the sequence name or the cursor,
and then the operation is started from
the searched sequence by pressing the CYCLE START switch.
The operating procedure for the sequence number search is described below.
Sequence Number Search by Sequence Name or No. of Blocks
When the main program is selected correctly in automatic mode, perform the following operation.
(1)
Press AUTO.
fclMU,
|
me
V
8
BS
l§t§
7
7 7 7
7
Z 7
/
(5) Press WRITE.
(4) Key in the sequence name.
(2)
Press function
key [F8] (EXTEND) twice.
(3) Press function key [F1J (NUMBER SEARCH).
Fig.
5-3 Sequence Search by Sequence Name or No. of Blocks
(1) Press the AUTO key.
(2) Press function key [F8] (EXTEND) twice.
Function names such as [F1] NUMBER SEARCH will be displayed.
(3) Press function key [F1] (NUMBER SEARCH). "NS"
is displayed on the
21st
line of the display
screen.
(4) Enter the specified sequence name or the required number of blocks.
(5)
Press the WRITE key.
The sequence name is searched for from the
main program head currently selected, and the
sequence pointer moves to the found sequence
name position. When the number of blocks has
been keyed in, the search is made in the specified number (either positive or negative) of blocks
from the currently located pointer position.