Page Mode - Okuma OSP-U100M Operation Manual

4203-E P-242
SECTION
2 PROGRAM OPERATION
5-12.
Page Mode
In the page mode (P mode), displayed
screen is fixed and keying in of a character, etc. overwrites the
existing screen data. For the input on the screen, insert mode (I mode) is also provided in which keyed in
characters, etc. are inserted. For details of the insert mode, refer
to 5-13. "Insert Mode".
This page mode
is
used in the following cases:
{1) creating a new file
(2) replacing one character in an existing file
(3) adding a character-string to the end of a line
The operating procedure is as indicated below.
Press function key [F6] (PAGE MODE) "P MODE" will be displayed on the
1st
line of the screen.
"P MODE" is displayed.
/
i
PROG OPERATION EDIT P MODE WHEEL100.MIN
I
97/07/15 14110:00
>>01000
N100 GOO
N101
G56
N103 G41G01
N104 G03
X300 Y300 S250
Z-55
M09 M03
X400 Y200
FI 00
X500 Y300 10
X100 Y300
I -200
JO
X200 Y200 1 100
JO
Dll
J100
N105
N106
N107
G01
N108
G40
N109 GOO
X400
X300
Y200
2100
N110
N111
=E
WHEEL100.MIN
file
end
>
>EX
INSERT PAGE
FIND CHANGE COPY MOVE EXTRACT
[EXTENDiy
MODE
MODE
FI
)
F2
F3 ) F4
F5
F6 F7 F8
Press [F6] (PAGE MODE).
(a) When a character is keyed in in the page mode, the cursor-located character is replaced by
the keyed-in character and the cursor moves
to the
right. In other words,
in the page mode,
the cursor is moved to the right and the character (including a space) located by the cursor
is
replaced by a keyed-in character each time data
is
entered. Therefore, if an
attempt has been
made to
assign a character-string many digits of characters, subsequent character
data might
be replaced.
(b) If one line has more than 63 characters, such a line is displayed in two lines on the
screen with
the second line preceded by These lines are processed as one line. In this case, the edit
pointer and the edit line move
to the lower line.
(c) Each page has a total of
1
6 lines for edit operation.
When the WRITE key is pressed while the bottom lineis designated as the edit line,
1
6 lines of data
are shifted by one line each and a blank line
is
created on the 16th line. The edit line does
not
change and the edit pointer is placed
at
the beginning of that line.