Log Monitor (Filter) - Centrecom FS980M/9 Command Reference Manual

L C
OGGING OMMANDS
( )
LOG MONITOR FILTER

log monitor (filter)

Overview This command creates a filter to select messages to be sent to the terminal when
the
priority/severity of the message, the program that generated the message, the
logging facility used, a sub-string within the message or a combination of some or
all of these.
log monitor [level <level>] [program <program-name>] [facility
Syntax
<facility>] [msgtext <text-string>]
no log monitor [level <level>] [program <program-name>]
[facility <facility>] [msgtext <text-string>]
Parameter Description
level
Filter messages by severity level.
<level>
The minimum severity of message to send. The level can be specified as one of the following
numbers or level names, where 0 is the highest severity and 7 is the lowest severity:
0|emergencies
1|alerts
2|critical
3|errors
4|warnings
5|notices
6|informational
7|debugging
program
Filter messages by program. Include messages from a specified program.
<program-
The name of a program to log messages from, either one of the following predefined program
name>
names (not case-sensitive), or another program name (case-sensitive) that you find in the log
output:
rsvp
dot1x
lacp
stp
rstp
mstp
imi
imish
epsr
613-50137-01 Rev A
terminal monitor command is given. Selection can be based on the
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Resource Reservation Protocol (RSVP)
IEEE 802.1X Port-Based Access Control
Link Aggregation Control Protocol (LACP)
Spanning Tree Protocol (STP)
Rapid Spanning Tree Protocol (RSTP)
Multiple Spanning Tree Protocol (MSTP)
Integrated Management Interface (IMI)
Integrated Management Interface Shell (IMISH)
Ethernet Protection Switched Rings (EPSR)
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
286