Advertisement
GUI C
OMMANDS
-
ATMF TOPOLOGY
GUI ENABLE
atmf topology-gui enable
Overview
Use this command to enable the operation of AMF Vista Manager on the Master
device.
Use the no variant of this command to disable this feature.
Syntax
atmf topology-gui enable
no atmf topology-gui enable
Default
By default the GUI support will not be enabled on AMF Master devices. An AMF
Controller device will have the GUI enabled by default. Regular nodes (not master
or controller) will always have it disabled.
Mode
Global Configuration mode
Usage
This command is run from an AMF Master node. Topology information about your
network is displayed in the GUI. For example; Node Name, status (i.e. link state,
node status and recovery status), Role (i.e. Master or Controller) and IP address.
Example
To enable AMF Vista Manager on Node1, use the following commands:
Node1#
Node1(config)#
To disable AMF Vista Manager on Node1, use the following commands:
Node1#
Node1(config)#
Related
atmf enable
Commands
gui-timeout
log event-host
service http
613-50137-01 Rev A
configure terminal
atmf topology-gui enable
configure terminal
no atmf topology-gui enable
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
161
Advertisement
Troubleshooting
