Centrecom FS980M/9 Command Reference Manual page 183

S C M
YSTEM ONFIGURATION AND
FINDME
To activate the Find Me feature for the default duration (60 seconds) on switch port
interfaces port1.0.2 through port1.0.4, use the following command:
awplus#
In the example above, ports 2 to 4 will flash 4 times and then all ports will flash
twice. Each alternate flash will be amber (if that device has amber LEDs). This
pattern will repeat until timeout (default or set) or no findme commands are used.
To deactivate the Find Me feature, use the following command:
awplus#
To activate the Find Me feature for the default duration on stack member 2, use the
following command:
awplus#
In the example above, all ports on member 2 will flash 4 times and then all ports in
the stack will flash twice. Each alternate flash will be amber (if that device has
amber LEDs). This pattern will repeat until the timeout (default or set) expires or
the no findme command is used.
613-50137-01 Rev A
C
ONITORING OMMANDS
findme interface port1.0.2-1.0.4
no findme
findme member 2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
183