Drift; Power └ └ /Hz; Aoa Elevation, Aoa Azimuth - R&S SMW-K44 User Manual

Satellite Navigation
Code Phase Drift ← LOS and Echoes Table
Sets a code phase drift that influences the delay of the echoes.
"Code Phase Drift" and "Doppler Shift" are interdependent. Changing either of them
affects the value of the other.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MPATh[:V<us>:A<gr>]:
ECHO<s2us0>:CPDRift
(etc. for the other GNSS systems)
Power Offset ← LOS and Echoes Table
Sets the additional power offset for the echo.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MPATh[:V<us>:A<gr>]:
ECHO<s2us0>:POWer
(etc. for the other GNSS systems)
Init. Carrier Phase ← LOS and Echoes Table
Sets the carrier phase at the simulation start.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MPATh[:V<us>:A<gr>]:
ECHO<s2us0>:CPHase
(etc. for the other GNSS systems)
Doppler Shift /Hz ← LOS and Echoes Table
Enters the additional Doppler shift that influences the delay of the echoes.
"Code Phase Drift" and "Doppler Shift" are interdependent. Changing either of them
affects the value of the other.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MPATh[:V<us>:A<gr>]:
ECHO<s2us0>:DSHift
(etc. for the other GNSS systems)
AoA Elevation, AoA Azimuth ← LOS and Echoes Table
Sets the angle of arrival parameters elevation and azimuth.
These parameters are considered if non-isotropic antenna patterns are used.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MPATh[:V<us>:A<gr>]:
ECHO<s2us0>:AELEVation
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MPATh[:V<us>:A<gr>]:
ECHO<s2us0>:AAZimuth
(etc. for the other GNSS systems)
User Manual 1178.6379.02 ─ 01
on page 245
on page 246
on page 246
on page 247
on page 248
on page 248
Real-World Environment
Static Multipath
95