R&S SMW-K44 User Manual page 67

Satellite Navigation
3. Select "GNSS > Simulation Configuration > Satellites".
4. Select "GLONASS > SV# > SV Config".
5. In the "SV Configuration" dialog, select "Signals Configuration".
6. To generate a continuous wave signal, send on the GLONASS frequency, select:
a) "Primary Code > Off"
b) "Nav. Msg. Control > Off"
c) "Meander Sequence > Off"
d) "Time Sequence > Off"
7. For a Galileo satellite, you achieve the same effect as follows:
a) "Primary Code > Off"
b) "Secondary Code > Off"
c) "Nav. Msg. Control > Off"
8. To apply the modulation control settings of the current satellite to other SV ID,
select for example "SV-ID = All" and "Copy Modulation Control To"
Available modulation control settings depend on the GNSS system and selected
RF band.
See also:
●
Settings
SV signal configuration
User Manual 1178.6379.02 ─ 01
Chapter 19.10, "Signals and Power Configuration per
table.........................................................................................68
└ Signal State.....................................................................................................68
└ Signal Component.......................................................................................... 68
└ Primary Code.................................................................................................. 68
└ Seconadry Code............................................................................................. 68
└ Nav Msg Control............................................................................................. 69
└ Nav Msg Type, Pattern, Data
└ Nav Msg Content, Config................................................................................70
Space Vehicle Configuration
Modulation Control Settings
List................................................................... 69
Satellite", on page 259
67