Satellite Navigation
Simulation
Monitor.......................................................................................................................... 26
Data
State
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
Remote command:
[:SOURce<hw>]:BB:GNSS:STATe
Set to Default
Calls the default settings. The values of the main parameters are listed in the following
table.
Parameter
State
Scenario
Test Mode
Simulation Configuration
Logging
Remote command:
[:SOURce<hw>]:BB:GNSS:PRESet
Save/Recall Scenario
Accesses the "Save/Recall" dialog, that is the standard instrument function for saving
and recalling the complete dialog-related settings in a file. The provided navigation
possibilities in the dialog are self-explanatory.
The filename and the directory, in which the settings are stored, are user-definable; the
file extension is however predefined.
See also, chapter "File and Data Management" in the R&S SMW user manual.
Remote command:
[:SOURce<hw>]:BB:GNSS:SETTing:CATalog?
[:SOURce<hw>]:BB:GNSS:SETTing:STORe
[:SOURce<hw>]:BB:GNSS:SETTing:LOAD
[:SOURce<hw>]:BB:GNSS:SETTing:DELete
Predefined Scenario
Accesses the standard "File Select" dialog and allows you to select a predefined sce-
nario.
The available test scenarios depend on the installed SW options.
Once a scenario is selected, all parameters (simulated position, satellite configuration,
navigation data, etc.) are configured automatically. The sceanrio name is indicated,
see Scenario.
User Manual 1178.6379.02 ─ 01
Configuration............................................................................................... 25
Generation............................................................................................................26
on page 208
Value
Not affected by "Set to default"
None
Navigation
L1/GPS only
Off
on page 207
on page 209
on page 209
on page 209
on page 210
Getting Started
General Settings
24