R&S SMW-K44 User Manual page 201

Satellite Navigation
Marker Mode
Marker configuration for up to 3 marker channels. The settings are used to select the
marker mode defining the shape and periodicity of the markers. The contents of the
dialog change with the selected marker mode; the settings are self-explanatory.
"1PPS/10PPS/
1PP2S"
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:WIDTh
"Pulse"
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:DIVider
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:FREQuency?
on page 387
"Pattern"
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PATTern
"On/Off Period"
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:ONTime
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:OFFTime
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:MODE
Marker x Delay
Delays the marker signal at the marker output relative to the signal generation start.
Variation of the parameter "Marker x Delay" causes signal recalculation, regardless of
the indication "Current Range without Recalculation".
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:DELay
User Manual 1178.6379.02 ─ 01
Marker signal generated at:
●
The start of every second
●
10 times per second or once every 100 ms
●
Once every two seconds
Set the "Pulse Width" in the corresponding field.
Regular marker signal.
To define the pulse frequency, set the divider. The pulse frequency is
derived by dividing the chip rate by the divider; the resuliting "Fre-
quency" value is displayed.
Marker signal that is defined by a bit pattern. The pattern has a maxi-
mum length of 64 bits.
Regular marker signal that is defined as on-time and off-time; a
period lasts one on and off cycle.
Signal Generation Control
Marker Settings
on page 388
on page 387
on page 387
on page 387
on page 387
on page 386
on page 385
201