Table of Contents
Advertisement
Satellite Navigation
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:DESTination:FILE:DIRectory
on page 376
[:SOURce<hw>]:BB:GNSS:LOGGing:DESTination:FILE:TAPPend[:STATe]
on page 376
Logging formats and categories
The logging categories and logging formats are listed in table form.
Each logging category is defined with:
State ← Logging formats and categories
Enables/disables logging of this particular category.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:SATellite:STATe
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:UMOTion:STATe
Format ← Logging formats and categories
Sets the file format in that the logged data is saved.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:UMOTion:FORMat?
Log Step, s ← Logging formats and categories
Sets the logging step, i.e. the resolution of the logged data per format and category.
Example:
A file generated in "Mode > Offline" with "Duration = 60s" and "Log Step = 10s" has six
records per SV ID.
The first one is made 10s after the "Simulation Start Time" + "Time Offset" and the next
steps are made after 10s each.
Observe also the file content of the log file. The first logged parameter
Elapsed_Time_ms indicates the log steps.
Remote command:
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:SATellite:STEP
[:SOURce<hw>]:BB:GNSS:LOGGing:CATegory:UMOTion:STEP
Configure Logging ← Logging formats and categories
Accesses the "Logging Satellites/User Motion" dialog to configure the messages to be
logged, see
15.2 Configure Logging Settings
Access:
1. Select "Data Generatiom > Data Logging".
User Manual 1178.6379.02 ─ 01
Chapter 15.2, "Configure Logging
Configure Logging Settings
Settings",
on page 175.
Data Logging
on page 376
on page 376
on page 376
on page 377
on page 377
175
Advertisement
Chapters
Table of Contents
