Signal Generation Control; Trigger Settings - R&S SMW-K44 User Manual

Satellite Navigation

18 Signal Generation Control

This section lists settings provided for defining the signal generation start and for gen-
erating signals necessary for synchronization with other instruments.
It covers the following topics:
● Trigger
● Marker
● Clock
● Local and Global Connector

18.1 Trigger Settings

Access:
► Select "GNSS > Trigger In".
This tab provides access to the settings necessary to select and configure the trig-
ger, like trigger source and mode, and to arm or trigger an internal trigger man-
ually. The current signal generation status is displayed in the header of the tab
together with information on the enabled trigger mode. As in the "Marker" and
"Clock" tabs, this tab provides also access to the settings of the related connectors.
This section focuses on the available settings.
For information on how these settings affect the signal, refer to section "Basics on ..."
in the R&S SMW user manual.
User Manual 1178.6379.02 ─ 01
Settings.....................................................................................................195
Settings..................................................................................................... 200
Settings....................................................................................................... 202
Settings....................................................................203
Signal Generation Control
Trigger Settings
195