Simulated Orbit And Orbit Perturbation Settings - R&S SMW-K44 User Manual

Satellite Navigation
Nav Msg Content, Config ← SV signal configuration table
Opens the "Navigation Message" dialog, where you can observe the navigation mes-
sage parameter and if enabled, change them.
See
Meander Sequence ← SV signal configuration table
Enables meandering, i.e. doubling the data rate of a GLONASS satellite navigation sig-
nal.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L1Band:CA:DATA:
MEANdering[:STATe]
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L2Band:CA:DATA:
MEANdering[:STATe]
Time Sequence ← SV signal configuration table
Enables the time signal component of GLONASS signals.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L1Band:CA:DATA:
TSEQuence[:STATe]
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L2Band:CA:DATA:
TSEQuence[:STATe]
Copy Modulation Control Settings to,SV-ID
Applies the power settings of the current satellite to the selected or to all SV-IDs of the
same GNSS system.
The following settings are considered:
●
Signal State
●
Primary Code
●
Seconadry Code
●
Nav Msg Control
●
Nav Msg Type, Pattern, Data List
●
Meander Sequence
●
Time Sequence
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MCONtrol:COPY:SVID
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MCONtrol:COPY:EXECute
on page 272
(etc. for the other GNSS systems)

9.3 Simulated Orbit and Orbit Perturbation Settings

Access:
1. Select "GNSS > Simulation Configuration > Satellites".
User Manual 1178.6379.02 ─ 01
Chapter 12, "Perturbations and Errors
on page 271
on page 271
on page 271
on page 271
Space Vehicle Configuration
Simulated Orbit and Orbit Perturbation Settings
Simulation", on page 101.
on page 271
70