Remote-Control Commands - R&S SMW-K44 User Manual

Satellite Navigation

19 Remote-Control Commands

The following commands are required for signal generation with the satellite navigation
options in a remote environment. We assume that the R&S SMW has already been set
up for remote operation in a network as described in the R&S SMW documentation. A
knowledge about the remote control operation and the SCPI command syntax are
assumed.
Conventions used in SCPI command descriptions
For a description of the conventions used in the remote command descriptions, see
section "Remote Control Commands" in the R&S SMW user manual.
The SOURce:BB:GPS|GALileo|GLONass|BEIDou subsystem contains commands
for configuring the GNSS standards.
Common suffixes
The following common suffixes are used in remote commands:
Suffix
SOURce<hw>
OUTPut<ch>
SVID<ch>
ECHO<s2us0>
V<st>
V<us>
A<ch>
A<gr>
STReam<st>
Required options
For an overview, see
User Manual 1178.6379.02 ─ 01
Value range Description
[1]|4 available baseband signals
1 to 3 available markers
1 to 37 for GPS satel- distinguishes between the SV IDs
lites
1 to 50 for Galileo
satellite
193 to 195 for QZSS
satellites
1 to 9 echoes in the multipath configuration
1 number of simulated vechicles
1 to 2 number of simulated antennas
1 to 2 number of GNSS streams
Chapter 3, "Required
Remote-Control Commands
Options", on page 14.
204