Time Conversion Errors Settings - R&S SMW-K44 User Manual

Satellite Navigation
Remote command:
[:SOURce<hw>]:BB:GNSS:SSValues

12.6 Time Conversion Errors Settings

Access:
1. Select "Simulation Configuration > Satellites > GNSS system > SV# > SV Config >
Signals Configuration".
2. Select "Nav Msg Control > Edit".
3. Select "Nav Msg Content > Config > Time Conversion".
Time conversion parameters are read-only and common for all SV of one GNSS
system.
4. To change the time conversion parameters of all GPS SVs for example, select
"SV# > SV Config" > "Copy Modulation Control to SV-ID = All".
Per default, the navigation message parameters are set to values, that correspond
to the values retrieved from the constellation data source.
Changing these values leads to deviation between the simulated and the broad-
casted navigation message and thus deliberated errors. SBAS corrections can be
activated for error compensation.
Available navigation message parameters depend GNSS system and selected
navigation message type.
Settings
GPS > Time
Galileo > Time
GLONASS > Time
BeiDou > Time
QZSS > Time
Show Scaled
User Manual 1178.6379.02 ─ 01
Conversion............................................................................................. 128
Conversion..........................................................................................128
Conversion....................................................................................129
Conversion......................................................................................... 129
Conversion........................................................................................... 130
Values................................................................................................... 131
Perturbations and Errors Simulation
Time Conversion Errors Settings
on page 284
127