R&S SMW-K44 User Manual page 199

Satellite Navigation
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger:EXTernal:SYNChronize:OUTPut
on page 384
External Inhibit/Trigger Inhibit ← Trigger Settings Common to All Basebands
For external trigger signal or trigger signal from the other path, sets the duration with
that any following trigger event is suppressed. In "Retrigger" mode, for example, a new
trigger event does not cause a restart of the signal generation until the specified inhibit
duration does not expire.
For more information, see chapter "Basics" in the R&S SMW user manual.
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger[:EXTernal]:INHibit
[:SOURce<hw>]:BB:GNSS:TRIGger:OBASeband:INHibit
External Delay/Trigger Delay
Delays the trigger event of the signal from:
●
The external trigger source
●
The other path
●
The other basebands (internal trigger), if common trigger settings are used.
Use this setting to:
●
Synchronize the instrument with the device under test (DUT) or other external devi-
ces
●
Postpone the signal generation start in the basebands compared to each other
For more information, see chapter "Basics on ..." in the R&S SMW user manual.
Remote command:
[:SOURce<hw>]:BB:GNSS:TRIGger[:EXTernal]:DELay
[:SOURce<hw>]:BB:GNSS:TRIGger:OBASeband:DELay
User Manual 1178.6379.02 ─ 01
Signal Generation Control
Trigger Settings
on page 386
on page 385
on page 385
on page 385
199