R&S SMW-K44 User Manual page 59

Satellite Navigation
4 = Visible and active SV, full power level
5 = Visible and inactive SV
6 = Not visible and inactive SV
7 = Excluded from the constellation
The information is color-coded. Icons provide further information:
●
Blue: active SV ID
●
Gray: Inactive SV ID
●
Sun: Visible SV ID
●
Cross out: SV ID is excluded form the constellation, for example if "SV ID > SV
Config" >
●
Power bar: Reduced height indicates enabled power offset i.e the signal of the SV
ID is transmitted with less power than the value indicated as "Configurable Nav.
Message"
The blocks are interactive. Select an SV ID to access further settings for changing its
state, enabling power offset of configuring the orbit simulation and navigation message
parameters.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID:GPS:LIST?
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:HEALthy?
(etc. for the other GNSS systems)
State (SV ID) ← Satellite's Constellation, SV ID
Changes the SV ID state on-the-fly.
Per default, only visible satellites can be included in the constellation. SV ID for that
Present in Constellation
Tip: Pressing the ON/OFF TOGGLE key has the same effect on the selected SV ID.
To enable any SV ID, set "Satellites > SV Selection Criteria > Selection Mode > Man-
ual".
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:STATe
(etc. for the other GNSS systems)
Power Offset ← Satellite's Constellation, SV ID
Reduces the signal of the selected SV ID by the defined value.
User Manual 1178.6379.02 ─ 01
("Satellite's Constellation, SV ID"
(Present in Constellation
Present in Constellation
> "Off" cannot be activated.
Satellite's Constellation
on page 58 = Off)
= "Off")
> "Off"
on page 257
on page 257
on page 263
Satellites Settings
59