R&S SMW-K44 User Manual page 356

Satellite Navigation
[:SOURce<hw>]:BB:GNSS:SVID<ch>:QZSS:SDYNamics:IVELocity
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:SDYNamics:IVELocity
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SDYNamics:IVELocity
[:SOURce<hw>]:BB:GNSS:SVID<ch>:SBAS:SDYNamics:IVELocity
[:SOURce<hw>]:BB:GNSS:SVID<ch>:BEIDou:SDYNamics:IVELocity
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SDYNamics:IVELocity <InitialVelocity>
Indicates the initial velocity, used at the beginning of the profile.
Parameters:
<InitialVelocity>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:QZSS:SDYNamics:CONFig
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:SDYNamics:CONFig
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SDYNamics:CONFig
[:SOURce<hw>]:BB:GNSS:SVID<ch>:SBAS:SDYNamics:CONFig
[:SOURce<hw>]:BB:GNSS:SVID<ch>:BEIDou:SDYNamics:CONFig
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SDYNamics:CONFig
Selects between the predefined velocity profiles or a user-defined one.
Parameters:
<PredefinedConfi>
User Manual 1178.6379.02 ─ 01
<InitialVelocity>
<InitialVelocity>
<InitialVelocity>
<InitialVelocity>
<InitialVelocity>
float
Range:
Increment: 1E-4
*RST:
See Example "Configuring the signal dynamics"
See "Initial Velocity"
<PredefinedConfi>
<PredefinedConfi>
<PredefinedConfi>
<PredefinedConfi>
<PredefinedConfi>
<PredefinedConfi>
USER | VEL1 | VEL2
USER
User-defined
Profile parametrs are configurable.
VEL1
Low dynamics
Profile parametrs are read-only.
VEL2
High dynamics
Profile parametrs are read-only.
*RST:
Remote-Control Commands
-19042 to 19042
3.62
on page 99
VEL1
Signal Dynamics
on page 351.
356