R&S SMW-K44 User Manual page 384

Satellite Navigation
Return values:
<RMode>
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:GNSS:TRIGger:SLENgth <SLength>
Defines the length of the signal sequence to be output in the SINGle trigger mode.
Parameters:
<SLength>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:TRIGger:EXECute
Executes an internal trigger event.
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:GNSS:TRIGger:ARM:EXECute
Stops (arms) waveform output.
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:GNSS:TRIGger:EXTernal:SYNChronize:OUTPut <Output>
Enables signal output synchronous to the trigger event.
Parameters:
<Output>
Example:
Manual operation:
User Manual 1178.6379.02 ─ 01
STOP | RUN
*RST: STOP
See Example "Configure and enable triggering"
Query only
See "Running/Stopped"
integer
Range: 1 to 4294967295
*RST: 1023
See Example "Configure and enable triggering"
See "Trigger Signal Duration"
See Example "Configure and enable triggering"
Event
See "Execute Trigger"
See Example "Configure and enable triggering"
Event
See "Arm" on page 197
0 | 1 | OFF | ON
*RST: 1
See Example "Configure and enable triggering"
See "Sync. Output to External Trigger/Sync. Output to Trigger"
on page 198
Remote-Control Commands
on page 197
on page 197
on page 197
Trigger Settings
on page 382.
on page 382.
on page 382.
on page 382.
on page 382.
384