Clock Errors Settings - R&S SMW-K44 User Manual

Satellite Navigation
Show Scaled Values
Switches between scaled and unscaled values representation.
Navigation message values are recalculated automatically.
Remote command:
[:SOURce<hw>]:BB:GNSS:SSValues

12.5 Clock Errors Settings

Access:
1. Select "Simulation Configuration > Satellites > GNSS system > SV# > SV Config >
Signals Configuration".
2. Select "Nav Msg Control > Edit".
3. Select "Nav Msg Content > Config > Clock".
Per default, the navigation message parameters are set to values, that correspond
to the values retrieved from the constellation data source.
Changing these values leads to deviation between the simulated and the broad-
casted navigation message and thus deliberated errors. The generated signal can
be used for testing the receiver's ability to cope with errors.
SBAS corrections can be activated for error compensation.
Available navigation message parameters depend GNSS system and selected
navigation message type, see
Parameters and
User Manual 1178.6379.02 ─ 01
on page 284
Chapter 12.1.3, "About Clock and Time Conversion
Errors", on page 104.
Perturbations and Errors Simulation
Clock Errors Settings
124