R&S SMW-K44 User Manual page 271

Satellite Navigation
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L2Band:CA:DATA:
MEANdering[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L1Band:CA:DATA:
MEANdering[:STATe] <State>
Enables meandering, i.e. doubling the data rate of a GLONASS satellite navigation sig-
nal.
Parameters:
<State>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L2Band:CA:DATA:
TSEQuence[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L1Band:CA:DATA:
TSEQuence[:STATe] <State>
Enables the time signal component of GLONASS signals.
Parameters:
<State>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:SBAS:MCONtrol:COPY:SVID <Svid>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:QZSS:MCONtrol:COPY:SVID <Svid>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:MCONtrol:COPY:SVID <Svid>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:MCONtrol:COPY:SVID <Svid>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:BEIDou:MCONtrol:COPY:SVID <Svid>
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MCONtrol:COPY:SVID <Svid>
Sets the SV ID to that the configuration form the current satellite (SVID<ch>) is
applied.
Both SV IDs belong to the same GNSS system.
User Manual 1178.6379.02 ─ 01
Signals and Power Configuration per Satellite
0 | 1 | OFF | ON
*RST: 1
See
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:
SIGNal:L1Band:CA:DATA:TSEQuence[:STATe]
on page 271.
See "Meander Sequence"
0 | 1 | OFF | ON
*RST: 1
:SOURce1:BB:GNSS:SYSTem:GLONass:STATe 1
:SOURce1:BB:GNSS:SVID2:GLONass:SIGNal:L1Band:CA:DATA:MEANdering:STATe 1
:SOURce1:BB:GNSS:SVID2:GLONass:SIGNal:L1Band:CA:DATA:TSEQuence:STATe 1
See "Time Sequence" on page 70
Remote-Control Commands
on page 70
271