R&S SMW-K44 User Manual page 69

Satellite Navigation
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:SIGNal:L1Band:E1OS:DATA:
SCODe[:STATe]
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:SIGNal:L1Band:E1OS:PILot:
SCODe[:STATe]
(etc. for the other GNSS systems)
Nav Msg Control ← SV signal configuration table
Defines whether the navigation message parameters can be changed or not.
"On/Edit"
"Off"
"Auto"
Remote command:
"Test Mode = Navigation"
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:CA:DATA:
NMESsage:CONTrol
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:P:DATA:
NMESsage:CONTrol
"Test Mode = Tracking"
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:CA:DATA:
NMESsage[:STATe]
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:P:DATA:
NMESsage[:STATe]
(etc. for the other GNSS systems)
Nav Msg Type, Pattern, Data List ← SV signal configuration table
Sets the data source used for the generation of the navigation message.
"LNAV/CNAV/INAV/DNAV/NAV"
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:CA:DATA:
NMESsage:TYPE
(etc. for the other GNSS systems)
User Manual 1178.6379.02 ─ 01
on page 269
on page 269
Enables configuration of the navigation message parameters.
Navigation message content of the SBAS SV is set automatically. To
enable the navigation message for configuration, set "Satellites" >
Error Correction Mode
phere& SV Errors)".
If "Satellites" > Error Correction Mode
Sync Atmosphere& SV Errors", the navigation message content of all
other GNSS systems than SBAS is configured automatically. Editing
is not possible.
Navigation message is disabled.
In Test Mode = "Navigation", the navigation message parameters are
adjusted automatically.
on page 269
on page 269
on page 353
on page 353
The navigation message parameters are "real" since they are
retrieved from the loaded simulation data source file, see
stellation.
To change the automatically filled in values, select:
●
Nav Msg Control = "Edit"
●
Nav Msg Content >
on page 270
Space Vehicle Configuration
Modulation Control Settings
= "Replay Historical Data (and Sync Atmos-
= "Replay Historical Data and
Config.
Import Con-
69