Satellite Navigation
18.2 Marker Settings
Access:
► Select "GNSS > Marker".
This tab provides access to the settings necessary to select and configure the
marker output signal, like the marker mode or marker delay settings.
This section focuses on the available settings.
For information on how these settings affect the signal, refer to section "Basics on ..."
in the R&S SMW user manual.
Routing and enabling a marker
The provided marker signals are not dedicated to a particular connector. They can be
mapped to one or more globally shared USER or local T/M connectors.
To route and enable a marker signal, perform the following general steps:
●
Define the shape of the generated marker, i.e. select the "Marker > Mode".
●
Define the connector (USER or T/M) where the selected signal is provided.
Use the
Settings:
Marker
Marker x
User Manual 1178.6379.02 ─ 01
Local and Global Connector
Mode............................................................................................................... 201
Delay............................................................................................................ 201
Signal Generation Control
Settings.
Marker Settings
200