Satellite Navigation
Remote command:
[:SOURce<hw>]:BB:GNSS:SYSTem:GPS:SIGNal:L1Band:CA[:STATe]
on page 213
[:SOURce<hw>]:BB:GNSS:SYSTem:GPS:SIGNal:L1Band:P[:STATe]
on page 213
(etc. for the other GNSS systems)
8.2 Satellites Settings
Access:
1. Select "GNSS > Simulation Configuration" > "Satellites".
In the "Satellite" dialog, you configure the satellites (SV ID) constellation for each
enabled GNSS system.
2. In the "Satellites" dialog, select the GNSS system for that you want to configure
satellites constellation.
3. To configure individual settings per SV, like power offset, used signals and the con-
tent of the navigation message each satellites transmitts, select "SV# > SV Config".
For description, see
In the "Satellite" dialog, you configure the satellite constellation.
Figure 8-1: Satellites constellation: Understanding the displayed information
1 = Enabled GNSS systems
2 = Number of active and available SVs per GNSS system
3 = Visible and active SV, that uses reduced power level
4 = Visible and active SV, full power level
5 = Visible and inactive SV
6 = Not visible and inactive SV
7 = Excluded from the constellation
User Manual 1178.6379.02 ─ 01
Chapter 9, "Space Vehicle
("Satellite's Constellation, SV ID"
(Present in Constellation
Satellite's Constellation
Satellites Settings
Configuration",
on page 61.
on page 58 = Off)
= "Off")
54