Clock Settings - R&S SMW-K44 User Manual

Satellite Navigation

18.3 Clock Settings

Access:
► Select "GNSS > Clock".
This tab provides access to the settings necessary to select and configure the
clock signal, like the clock source and clock mode.
This section focuses on the available settings.
For information on how these settings affect the signal, refer to section "Basics on ..."
in the R&S SMW user manual.
Defining the Clock
The provided clock signals are not dedicated to a particular connector. They can be
mapped to one or more globally shared USER and the local T/M/C connectors.
Use the
polarity, the trigger threshold, and the input impedance of the input connectors.
To route and enable a trigger signal, perform the following general steps:
●
Define the signal source, that is select the "Clock > Source".
●
Define the connector (USER or T/M) where the selected signal is provided.
Use the
Settings:
Clock
Clock
Measured External
User Manual 1178.6379.02 ─ 01
Local and Global Connector Settings
Local and Global Connector
Source...............................................................................................................203
Mode................................................................................................................. 203
Clock............................................................................................ 203
Signal Generation Control
to configure the signal mapping, the
Settings.
Clock Settings
202