Output Streams - R&S SMW-K44 User Manual

Satellite Navigation
The available values depend on the selected "Receiver" >
SV Selection Criteria > Reference Vehicle
Option: R&S SMW-K120
(Access: "GNSS > Simulation Configuration > Satellites > SV Selection Criteria")
In "GNSS Advanced" mode, defines the vehicle for that the displayed satellite constel-
lation in the "Satellites" dialog applies.
"V2" is enabled if
Remote command:
[:SOURce<hw>]:BB:GNSS:SV:SELection:REFerence:VEHicle

14.2 Output Streams

Access:
1. Enable "GNSS Advanced" mode, see
on page 164.
2. Select "GNSS > Simulation Configuration > Output Streams".
In the default configuration, the GNSS signal is the signal of one vehicle ("V1") with
one antenna ("A1"). It is transmitted as GPS C/A signal modulated on the L1 band
and as GPS L2C signal in the L2 band.
Per default, "Stream A" carries the signal of the L1 band and "Stream B" the signal
of the L2 band.
You can change this mapping in terms of "RF Band", "Vehicle" and "Antenna". A
stream can be deactivated, too.
User Manual 1178.6379.02 ─ 01
Multi-Band, Multi-Antenna and Multi-Vehicle Scenarios
Receiver > Number of Vehicles
Number of
= "2".
"How to enable the advanced mode "
Output Streams
Antennas.
on page 381
167