Table of Contents
Advertisement
Satellite Navigation
[:SOURce<hw>]:BB:GNSS:L1Band[:STATe] <L1BandState>
[:SOURce<hw>]:BB:GNSS:L2Band[:STATe] <L2BandState>
Activates the RF band.
Parameters:
<L2BandState>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:SYSTem:BEIDou[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:GALileo[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:GLONass[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:QZSS[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:SBAS:EGNOS[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:SBAS:GAGAN[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:SBAS:MSAS[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:SBAS:WAAS[:STATe] <State>
[:SOURce<hw>]:BB:GNSS:SYSTem:GPS[:STATe] <State>
Defines if satellites from the selected GNSS system are included in the simulated sat-
ellites constellation.
Parameters:
<State>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:SYSTem:SBAS[:STATe]?
Queries if at least one of the SBAS system is enabled.
Return values:
<State>
Example:
User Manual 1178.6379.02 ─ 01
0 | 1 | OFF | ON
*RST:
0
See
Example "Configuration example"
See
"L1, L2"
on page 52
0 | 1 | OFF | ON
Disabling a GNSS system deactivates all SVID and signals from
this system.
*RST:
0
See
Example "Configuration example"
See
"Systems"
on page 52
0 | 1 | OFF | ON
1
At least one SBAS system is enabled.
To enable each of the SBAS systems, use the corresponding
command, e.g.
[:SOURce<hw>]:BB:GNSS:SYSTem:SBAS:
EGNOS[:STATe].
0
All SBAS systems are disabled.
*RST:
0
See
Example "Configuration example"
Remote-Control Commands
Systems and Signals
on page 211.
on page 211.
on page 211.
212
Advertisement
Chapters
Table of Contents
