Table of Contents
Advertisement
Satellite Navigation
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:ONTime <OnTime>
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:OFFTime <OffTime>
Sets the number of chips during which the marker output is on or off.
Parameters:
<OffTime>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PATTern <Pattern>
Defines the bit pattern used to generate the marker signal.
Parameters:
<Pattern>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
Sets the divider for pulse marker mode (PULSe).
Parameters:
<Divider>
Example:
Manual operation:
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal. The pulse frequency is
derived by dividing the symbol rate by the divider.
Return values:
<Frequency>
Example:
Usage:
Manual operation:
User Manual 1178.6379.02 ─ 01
integer
Range:
11 ns to 182.2 ms
*RST:
11 ns
Default unit: s
See
Chapter 19.18, "Marker
See
"Marker Mode"
on page 201
64 bits
See
Chapter 19.18, "Marker
See
"Marker Mode"
on page 201
integer
Range:
2 to 1024
*RST:
2
See
Chapter 19.18, "Marker
See
"Marker Mode"
on page 201
float
See
Chapter 19.18, "Marker
Query only
See
"Marker Mode"
on page 201
Remote-Control Commands
Marker Settings
Settings",
on page 386
Settings",
on page 386
Settings",
on page 386
Settings",
on page 386
387
Advertisement
Chapters
Table of Contents
