Table of Contents
Advertisement
Satellite Navigation
6. To observe current satellite constellation, select "GNSS > Simulation Monitor".
7. To reconfigure the satellites constellation, select "Simulation Monitor > Config".
8. In the block diagram, select "RF > On".
The signal generation starts.
The frequency and level of the generated RF signal are configured automatically.
Further settings are not required.
For description of the related settings, see:
●
●
●
5.2 General Settings
Access:
► Select "Baseband > Satellite Navigation > GNSS".
This dialog comprises the standard general settings.
The remote commands required to define these settings are described in
ter 19.2, "General
Settings:
State..............................................................................................................................24
Scenario........................................................................................................................ 25
User Manual 1178.6379.02 ─ 01
Chapter 5.2, "General
Chapter 5.3, "Simulation
Chapter 8, "Satellite's
Settings",
Default................................................................................................................ 24
Scenario....................................................................................................24
Scenario......................................................................................................24
Mode..................................................................................................................... 25
Settings",
on page 23
Monitor",
on page 26
Constellation",
on page 51
on page 206.
Getting Started
General Settings
Chap-
23
Advertisement
Chapters
Table of Contents
