Epson S1D13504 Technical Manual page 265

Epson Research and Development
Vancouver Design Center
Program Messages
13504PWR Software Suspend Power Sequencing Utility
Issue Date: 01/02/01
ERROR: Unknown command line argument.
An invalid command line argument was entered. Enter a valid command line argument.
ERROR: Already selected SOFTWARE.
Command line argument /softwar e was selected more than once. Select /software only once.
ERROR: Already selected HARDWARE.
Command line argument /hardware was selected more than once. Select /hardware only once.
ERROR: Already selected ENABLE.
Command line argument /enable was selected more than once. Select /enable only once.
ERROR: Already selected DISABLE.
Command line argument /disable was selected more than once. Select /disable only once.
ERROR: Select /software or /hardware.
Neither command line argument /software or /hardware was selected . Select /software or
/hardware.
ERROR: Select /enable or /disable.
Neither command line argument /enable or /disable was selected . Select /enable or
.
/disable
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL can only manage 10 devices
simultaneously.
ERROR: Could not register S1D13504 device.
A 13504 device was not found at the configured addresses. Check the configuration address using
the 13504CFG configuration program.
ERROR: Did not detect S1D13504.
The HAL was unable to read the revision code register on the S1D13504. Ensure that the S1D13504
hardware is installed and that the hardware platform has been set up correctly.
Page 5
S1D13504
X19A-B-007-04