Epson S1D13504 Technical Manual page 347

Epson Research and Development
Vancouver Design Center
Windows 98/ME
All PCI Bus Evaluation Cards
All ISA Bus Evaluation Cards
S1D13XXX 32-Bit Windows Device Driver Installation Guide
Issue Date: 01/04/17
1. Install the evaluation board in the computer and boot the computer.
2. Windows will detect the new hardware as a new PCI Device and bring up the ADD
NEW HARDWARE dialog box.
3. Click NEXT.
4. Windows will look for the driver. When Windows does not find the driver it will al-
low you to specify the location of it. Type the driver location or select BROWSE to
find it.
5. Click NEXT.
6. Windows will open the installation file and show the option EPSON PCI Bridge Card.
7. Click FINISH.
1. Install the evaluation board in the computer and boot the computer.
2. Go to the CONTROL PANEL and double-click on ADD NEW HARDWARE to
launch the ADD NEW HARDWARE WIZARD. Click NEXT.
3. Windows will attempt to detect any new plug and play device and fail. Click NEXT.
4. Windows will ask you to let it detect the hardware, or allow you to select from a list.
Select NO, I WANT TO SELECT THE HARDWARE FROM A LIST and click
NEXT.
5. From the list select OTHER DEVICES and click NEXT.
6. Click HAVE DISK and type the path to the driver files, or select browse to find the
driver.
7. Click OK.
8. The driver will be identified as EPSON PCI Bridge Card. Click NEXT.
9. Click FINISH.
Page 5
X00A-E-003-04