Leg Rest Angle (Manual & Electrical Back) - Permobil Stander Service Manual

Adjustments
Leg rest angle
See the adjustment dependencies diagram on
page 6.
The leg rest's angle can be adjusted to suit all
users.
1. Loosen the screw located on the leg rest's
strut. The strut is found under the seat, inside
the stand function's actuator on the seat's
left side, see Fig. 27.
2. Set the leg rest to the desired angle.
3. Tighten the screw again.
4. Loosen the two screws holding the locking
jamb to the leg rest's belt. The locking jamb is
located behind the leg rest under the middle of
the seat, see Fig. 28-29.
5. With the seat in the sitting position, push the
leg rest up to its highest position, slide it along
the belt.
NOTE
The leg rest must be pushed up to its uppermost
position. Any other position might lead to damage to the
seat or injury to the users.
6. Tighten the belt's locking jamb again..
7. Carefully test out all the functions of the seat.
Check that the leg rest's angle feels
comfortable in all positions.
(Manual & Electrical Back)
Fig. 27. Setting the slope of the leg rest.
Fig. 28. The lock for the leg rest's belt is located
on the rear of the leg rest.
Fig. 29. Readjustment of the leg rest's belt.
16