Control Panel Vr2 - Permobil K300 Service Manual

Control panel VR2

Removal
1. Remove the upper and rear chassis cover.
See page 8.
2. Remove the cable ties holding the control
panel cabling in place. Note the positions of
the cable ties for subsequent fitting.
3. Disconnect the control panel cabling from the
output stage (see illustration).
4. Remove the control panel (3). It is held in place
with two screws underneath (see illustration).
assembly
Assemble in the reverse order.
The control panel cabling is connected
to the output stage.
3
The control panel is held in place with two screws.
37
Control panel