Control Panel R-Net; Control Panel Vr2 - Permobil C350 Service Manual

Control panel

Control panel R-net

Removal
1. Switch off the main power switch on the con-
trol panel.
2. Remove the cable ties holding the control
panel cabling in place under the arm rest. Note
the positions of the cable ties for subsequent
fitting.
3. Divide the control panel cabling at the contact
on the cabling.
4. Remove the control panel (1). It is held in
place with two screws (see illustration). These
two screws also hold the bracket for the ICS
control panel (2), if there is one fitted (see illus-
tration).
Assembly
Assemble in the reverse order.

Control panel VR2

Removal
1. Remove the upper and rear chassis cover.
See page 8.
2. Remove the cable ties holding the control
panel cabling in place. Note the positions of
the cable ties for subsequent fitting.
3. Disconnect the control panel cabling from the
output stage (see illustration).
4. Remove the control panel (3). It is held in
place with two screws underneath (see illus-
tration).
Assembly
Assemble in the reverse order.
1
The control panel is held in place with two screws.
The control panel cabling is connected
to the output stage.
3
The control panel is held in place with two screws.
36
2