Angle Adjustable Footrest; Adjusting The Angle - Permobil Aero Z 2 Series Owner's Manual

CHAPTER 3: FOOTRESTS
3. Adjust the footrest to the desired height. Standard Footrest measurement must be at least 2" shorter than the Front Seat
Height measurement. To measure Front Seat Height, measure from floor to top of seat tube at front edge of seat sling.
See Figure 3-3. Tighten the Allen screws in the clamp so the footrest height cannot change. Ensure proper ground
clearance for your surrounding environment after adjustment.
Note: When adjusting the height of the footrest, make sure that at least 4 cm of the extension tube remains up inside
the frame tube. See Figure 3-5.
4. Repeat the procedure from Step 2 above on the right side of the footrest.
5. When both sides are set at an equal distance from the floor and both casters are in contact with the floor, fully tighten
the two Allen screws into the two T-Nuts securing the footrest to the frame, making sure the covers remain securely
butted up against the end of the frame tube.

Angle Adjustable Footrest

Adjusting the Angle

Tools needed:
• 4 mm Allen Wrench
1. Loosen, but do not remove, the two Allen screws that secure the footplate to the clamp. See Figure 3-6.
2. Adjust the footrest to desired angle.
3. Tighten the Allen screws, making sure the screws and the locknuts are secure and will not permit the footplate to move
up or down under weight.
Permobil Aero Z & ZRA Owner's Manual
Figure 3-4
Replacing
Frame
Allen
Screws
Clamp
T-Nuts
Clamp
Plate
Footrest
Cover
Figure 3-5
Adjusting the Height
Frame
Footrest
3-3 OM0004-ENGLISH_Rev E_Aero Z_ZRA